
-
LED Edge Lighting
Full-perimeter 24V white LEDs
-
Ride-On Low Profile
0.8 in high, with a non-slip rubber trim
-
3 Surfaces
Black carpet, gray stone or wood vinyl
-
2 Sizes
Standard 3 x 7.8 ft or XL 3.4 x 8.5 ft
-
Plug In and Go
Power supply included for a wall outlet
-
1-Year Warranty
Covered for one full year
Setup, cleaning and storage
Follow these guidelines. Not following them can permanently damage your Highlight Mat.
Installation
- Roll the mat out onto a flat, clean surface.
- Give it 15 to 30 minutes to lie flat without waves or bumps. It can take longer in a cold room.
- Plug it into the supplied power supply with the inline dimmer switch, or use it without the dimmer for constant full brightness.
Use
- Always drive straight onto the mat.
- Plug and unplug the connector at the mat carefully. Forcing it can damage the wiring.
- If any part feels very hot to the touch, unplug it right away and contact support.
- Do not use any power supply or battery other than the one supplied with the mat.
- Do not drive over the corner caps.
- Do not lower a car or motorcycle with air ride or other adjustable suspension onto the mat while hot. It will melt the mat.
- Do not place wheel stands or other supports on the lit edge trim.
Carpet surface
- For regular cleaning, use a manual push carpet cleaner or a vacuum on a low to medium setting.
- For stains or spills, use a compatible spot cleaner spray and a brush.
- Do not use carpet shampoo machines or similar.
Vinyl surfaces
- Clean with mild soap and water, or a degreaser spray, and a microfiber towel.
Lit edge trim
- Wipe with a microfiber cloth, with mild soap and water if needed.
It is best not to store the Highlight Mat for long periods. When you do need to store it:
- Roll it up carefully, with an inside diameter no tighter than 8 in.
- Store and transport it horizontally, on its side.
- Never fold the mat.
- Do not stack heavy objects or other mats on top of it.
- Do not stand it upright when rolled.